RouterOS 7.2rc5 [Testing] がリリース

RouterOS 7.2rc5 [Testing]
日時: Wed, 23 Mar 2022 15:44:46 +0200
Channel: Testing
リンク: https://mikrotik.com/download/changelogs/testing

7.2rc5 changelog:

*) api - accept "Content-Type" with specified charset;
*) arm - fixed "auto" CPU frequency setting;
*) arm64 - improved Watchdog initiated reboot reason reporting;
*) backup - fixed cloud backup's creation timezone;
*) bgp - added BGP advertisements display (requires output.keep-sent-attributes to be set);
*) bgp - fixed link-local iBGP address selection;
*) bgp - fixed network advertisement from address-lists after reboot;
*) bridge - fixed firewall "ingress-priority" matcher and "new-priority=from-ingress" action settings from VLAN tagged frames;
*) ccr2004 - improved system stability on CCR2004-12S+2XS;
*) crs1xx/2xx - fixed static switch host addresses after link down;
*) crs1xx/2xx - ignore static bridge host addresses (switch unicast-fdb should be used instead);
*) dhcpv6 - added VRF support;
*) dude - fixed The Dude client compatibility with RouterOS v7;
*) firewall - improved available port lookup for source NAT when free port range is exhausted;
*) ipsec - fixed "identities" menu emptying after RouterOS upgrade/reboot;
*) ipv6 - do not add duplicate dynamic prefix when static already exists;
*) ipv6 - fixed "retransmissit-interval" unit value;
*) ipv6 - fixed VLAN tagged PPPoE packet receiving on RB5009;
*) l2tp - fixed CHAP challenge packet processing over IPsec;
*) l3hw - improved routing table offloading for CRS305, CRS326-24G-2S+, CRS328, netPower, netFiber devices;
*) led - fixed LED behavior on Audience;
*) led - reduced LTE signal LED range to -70;
*) log - added warning message when connection tracking table is full;
*) lte - add IPv6 address on interface as well;
*) lte - added support for Uplink CA reporting;
*) lte - changed "CS/PS" registration type from "both" to "any" on R11e-LTE un R11e-LTE6;
*) lte - do not loose "band" configuration after reboot on Chateau 5G;
*) lte - fixed AT command response handling on R11e-LTE;
*) lte - fixed MBIM modem reset on AT timeout;
*) lte - fixed link flapping when loosing cellular signal on R11e-LTE un R11e-LTE6;
*) ntp - improved service stability when none of the NTP servers are reachable for a while;
*) ospf - general stability improvements;
*) ospf - improved DB retransmit logging;
*) ospf - send notifies for neighbors;
*) ovpn - improved memory allocation on Tile in "ethernet" mode;
*) ovpn - improved system stability in high load scenarios;
*) pimsm - fixed menu prints;
*) pimsm - general stability improvements;
*) queue - fixed queued IPv6 traffic considered as "invalid" by Firewall;
*) rb4011 - fixed jumbo frame processing on SFP+ port when using 1G module;
*) rip - added logging;
*) rip - fixed route metrics;
*) rip - fixed route redistribution;
*) rip - use nexthop with interface;
*) route - fixed "table" menu emptying after RouterOS upgrade;
*) route - fixed BGP atomic aggregate value;
*) route - fixed ECMP route removal;
*) route - general stability improvements;
*) routerboard - fixed "ether2" interface presence on some RBwAPGR devices;
*) routerboard - fixed WPS button functionality on Audience;
*) routing - added PCAP viewer tool for BGP advertisements debugging purposes;
*) routing-filter - fixed "bgp-*-communities-empty" matcher;
*) sfp - improved SFP module detection on CRS106 and CRS112;
*) smips - improved RAM allocation;
*) switch - added "rx-overflow" counter for 88E6393X (RB5009) and 88E6191X (CCR2004-16G-2S+) switch chips;
*) switch - improved packet forwarding with enabled "cpu-flow-control" setting between different rate interfaces for 88E6393X (RB5009) and 88E6191X (CCR2004-16G-2S+) switch chips;
*) tr069-client - added support for 5G band configuration;
*) tr069-client - added support for wireless "skip-DFS" configuration;
*) winbox - added missing "3GGP RAW" parameter under "Interface/Wireless/Interworking Profile" menu;
*) winbox - added missing "accounting", "interim-update" and "radius-password" parameters under "IP/DHCP Server" menu;
*) winbox - allow adding more than 100 tagged/untagged interfaces under "Bridge/VLAN" menu;
*) winbox - allow configuring "VTEP" under "Interface/VXLAN" menu;
*) winbox - fixed "00:00:00" time printing;
*) winbox - fixed switch related settings for MT7621 switch chip (hEX, hEX S, RBM33G, RBM11G, LtAP);
*) winbox - moved IPv4 and IPv6 "Rules" menus under "Routing" menu;
*) winbox - properly show "v" flag instead of "y" under "IP/Route" menu;
*) winbox - properly update server list under "System/NTP Client/Servers" menu;
*) winbox - show "System/Health/Settings" only on boards that have configurable values;
*) www - fixed "tls-version" for SSL;
*) x86 - allow to select disk for install image;
*) x86 - fixed NVME partition path;
*) zerotier - fixed IPv6 support;

Download the new 'RouterOS 7.2rc5' version here: https://mikrotik.com/download

Twitterには書いたのですが、以下の環境でROSv7になってから動作しなくなっていた、IPv6 > mangle でmark packetしたあと、queueへ流せなくなっていた件について改善しているようです。

確認環境

  • CCR1009-8G-1S-1S+
  • ROS 7.2rc5

他の機種ではどうでしょうか?(そもそもQoSを使用している人は少ない?)